Gasboy Kit M04477K001 - Manual (Page 11)

MDE-4291 Gasboy Gear Train Upgrade Kit M04477K001 • March 2004 Page 11
Installing the Gear Train Upgrade Kit
Figure 9: Meter Interface Link
3 Reversing the removal process, position the gear train back in between the meter mounting
brackets and the meters as before.
4 Install the shorter display drive shaft (M04433B001) (see Figure 10 ) between the gear train
and the register.
Figure 10: Display Drive Shaft
5 Remove the two 1X4s and set the register platform back down on the frame rails while trying
to align the meter interface links and the four meter-mounting-brackets to the meters.
6 Insert and loosely thread the four bolts that mount the gear train assembly to the register
platform. (Do not tighten until all bolts are threaded into their respective locations.)
7 Insert and thread the eight bolts securing the meters and the eight bolts that mount the register
platform to the frame, so that they are still loose - not tightened. (This is required so as to
enable the alignment of all the bolts into their respective holes.)
8 Once all the bolts are inserted and threaded in loosely, tighten all twenty bolts.
Testing/Checking Operation
1 Restore power to the unit.
2 Slowly dispense fuel and observe that the digits turn smoothly and that no binding is
occurring.
Guide Pins