GAI-Tronics L3149B C200 Advanced Deskset - Manual (Page 19)

L3149B (C200) Advanced Tone Remote Desk Set Operation
13
VOLUME Up and VOLUME Down Buttons
Press the
VOLUME
Up or Down buttons to adjust the local speaker volume if the handset is on-hook. The
handset speaker volume is adjusted if the handset is off-hook.
The display shows the new setting for 2 seconds after a volume change. The internal, handset, and
accessory each have individual settings. When the handset is off-hook, the following message is
displayed:
HANDSET VOL: X
The
VOLUME
Up and
VOLUME
Down buttons adjust the sensitivity of the microphone that is currently in
use. While holding down the
TRANSMIT
button, handset PTT bar, or the accessory PTT, press the
VOLUME
Up or
VOLUME
Down buttons. This display will indicate the MIC SENSITIVITY setting in a
range of 1 to 5 with 1 being the least sensitive and 5 the most sensitive. Note that each microphone,
internal, handset, and accessory each has its own independent sensitivity setting. Refer to the Settings and
Adjustments in the Installation section of this manual for more information.
Pressing the
LOCK
+
VOLUME
Up buttons will activate the internal speaker when the handset is off-hook.
This can be used if others must hear the conversation. When the handset is returned to the cradle, this
setting is reset so that if the handset is again removed from the cradle, the internal speaker is not active.
Pressing the
LOCK
+
VOLUME
Down buttons will mute the internal speaker indefinitely. Pressing
VOLUME
Up,
VOLUME
Down,
LOCK
+
VOLUME
Up, or removing the handset from the cradle and
returning it will reset this setting.
LOCK Button
The
LOCK
button is used in conjunction with other buttons for additional button operation.
IC (Intercom) Button
To communicate between desk sets without transmitting over the radio channel, press and hold the IC
button. Microphone audio is routed to the line without activating the radio transmitter. Other desk sets on
the same line will hear the audio automatically. Note that when configured for 4-wire operation, the
internal intercom path must be enabled by the programming software for parallel units to hear intercom
audio.
MONITOR Button
When the
MONITOR
button is pressed, the desk set, adapter, and the radio are placed in the monitor mode
(PL/DPL disabled), the
MONITOR
LED illuminates, and the display indicates
MON
. Press this button
before making a call to ensure a clear radio channel is available.
TRANSMIT Button
Press this button to place the desk set in the transmit mode. See the Initiating Calls section. When the
TRANSMIT
button is pressed and a channel has been established, the
TRANSMIT
LED illuminates, and
MONITOR
LED (if lit) extinguishes. The display indicates the mode and current frequency selected.
Keypad Buttons
The numeric keypad is used for various uses including the selection of a desired frequency, page capcode
entry, and MDC1200 ID entry. See Numeric Keypad Frequency Selection in this section of the manual
for further information.