Fronius Energy Package User Manual

Page 26

Controls, connec-
tions and indica-
tors on the
system monitor-
ing unit

No. Function
(1)

IP switch
For switching the IP address:
Switch position A
Default IP address with opening of the WLAN access point

System monitoring uses the set IP address 169.254.0.180 to establish a direct
connection to a PC via LAN.

Setting the IP switch to position A also opens an access point to enable a direct
WLAN connection to the system monitoring datalogger.

Access data for this access point:
Network name: FRONIUS_239.XXXXXX
Code: 12345678

System monitoring can be accessed by:
-

Using the DNS name “http://datamanager”

Using the IP address 169.254.0.180 for the LAN interface

Using the IP address 192.168.250.181 for the WLAN access point

Switch position B
Assigned IP address

System monitoring uses an assigned IP address (factory setting: dynamic (DH-
CP))
The IP address can be set on the system monitoring web page.

(2)

WLAN LED
-

Flashing green: System monitoring is in Service mode
(IP switch on the system monitoring plug-in card is in position A or Service
mode has been activated via the inverter display, the WLAN access point is
open)

Steady green: WLAN connection established

Flashing alternately green/red: WLAN access point has timed out following ac-
tivation (1 hour)

Steady red: No WLAN connection

Flashing red: Faulty WLAN connection

(5)

(1)

(6)

(7)

(8)

(9)

(4)

(2)

(3)

LAN