Fronius Energy Package - Manual (Page 113)

111
EN
Code Description Behaviour Remedy
401 Unable to communicate with the power
stage set
The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid.
*)
406 DC module temperature sensor faulty
(PV)
407 AC module temperature sensor faulty
408 DC component measured in the grid too
high
412 Fixed voltage mode has been selected
instead of MPP voltage mode, and the
fixed voltage has been set to too low or
too high a value.
- **)
415 Safety cut-out via option card or RECER-
BO has triggered The inverter is not feeding
any energy into the grid. *)
416 No communication possible between
power stage set and control system. The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid.
*)
417 Hardware ID problem
The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid.
Update inverter firm-
ware; *)
420 Unable to communicate with system
monitoring
425 Unable to communicate with the power
stage set
426 -
427 Possible hardware fault
431,
432 Software problem
The inverter is not feeding
any energy into the grid.
Perform AC reset
(switch automatic circuit
breaker off and on
again); update inverter
firmware; *)
436 Functional incompatibility (one or more
PC boards in the inverter are not com-
patible with each other, e.g. after a PC
board has been replaced) The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid.
Update inverter firm-
ware; *)
437 Power stage set problem
438 Functional incompatibility (one or more
PC boards in the inverter are not com-
patible with each other, e.g. after a PC
board has been replaced) The inverter will automati-
cally attempt to connect
again and, if possible, will
resume feeding energy into
the grid.
Update inverter firm-
ware; *)
445 - Compatibility error (e.g. due to re-
placement of a PC board)
- Invalid power stage set configura-
tion
The inverter is not feeding
any energy into the grid. Update inverter firm-
ware; *)
447 Insulation fault (PV or battery) The inverter is not feeding
any energy into the grid.
*)
450 Guard cannot be found