Fronius Energy Package - Manual (Page 25)

23
EN
Data communication
Data communica-
tion area
General remarks As standard, the inverter features the WLAN-enabled system monitoring and energy man-
agement unit (Fronius Hybrid Manager).
Various functions are included in system monitoring, such as:
-
Dedicated web page displaying current data and a wide range of different setting op-
tions
- Option of connecting directly to Fronius Solar.web
- Automatic sending of service messages by SMS or e-mail in the event of a fault
- Internet connection via WLAN or LAN
- Ability to control the inverter load by specifying power limit values, minimum or maxi-
mum running times or target running times (called “durations” in the software)
- Ability to control the inverter via Modbus (TCP)
- Ability to assign control priorities
- Ability to control the inverter by means of connected meters (Fronius Smart Meter)
- Ability to control the inverter via a ripple control signal receiver (e.g. by specifying the
reactive power or effective power)
- Dynamic power reduction, taking self-consumption into account
- Ability to control battery charging in line with the control targets set
Item Name
(1) Switchable multifunction current interface
Use the 2-pin mating connector supplied with the inverter to connect to the multi-
function current interface.
(2) Floating switch contact with mating connector
Max. 250 V AC / 4 A AC
Max. 30 V DC / 1 A DC
Max. 1.5 mm² (AWG 16) cable cross-section
Pin 1 = NO contact (normally open)
Pin 2 = C (common)
Pin 3 = NC contact (normally closed)
Use the mating connector supplied with the inverter to connect to the floating
switch contact.
(3) System monitoring with WLAN antenna
(1) (2)
PIN 1 PIN 2
PIN 1
PIN 2
PIN 3
(3)