Delta Electronics Modbus TCP Remote I/O Communication Module RTU-EN01 - Manual (Page 34)

Modbus TCP Remote I/O Communication Module RTU-EN01
DVP-PLC Operation Manual 32
3. Word device
For setting up the addresses for the word type serial slave device and reading or the content in the
designated slave.
„ Station address:
Enter the address of slave to be monitored. (Max. 16 slaves)
„ MODBUS (Hex):
Enter the 4-digit hex Modbus address of the slave to be monitored.
„ MODBUS (Dec):
Enter the 6-digit decimal Modbus address of the slave to be monitored.
„ Account:
Enter the number of slaves to be monitored continuously (Max. 100).
f Once the information of slave monitoring is set, click "Apply" to save the setting and start the
monitoring. Incomplete device information will be deleted.
„ Format:
Select the format of the register to be monitored, decimal (Dec), hexadecimal (Hex) or
binary.
„ Start/Stop monitor
Start or stop the saved and applied device number to be monitored. Unapplied saved
settings will be deleted.
Note:
The default is in cache enabled mode. You can set up maximum 16 sets of slave information for
the monitored bits and words (Max. 100 data). Under the cache mode, you are able to send the
read data back to the registers in RTU-EN01.