Fluke Biomedical MPS450 - Manual (Page 27)

Introduction and Specifications
Navigation in the MPS450
1
1-13
gje009.eps
3. Select BEEP to scroll to the LCD screen SET BEEPER MODE, which displays the
current setting (in this example, SHORT ):
gje010.eps
4. Scroll to the desired beeper mode. The setting is active when displayed and remains
active until the setting is changed.
5. To hear the audible beep as currently set, select TEST.
6. To store the beeper setting beyond the current session, select STORE. On the LCD
screen, Storing blinks on momentarily to indicate the value is being saved.
7. Press the ESC key to return to the top menu SETUP.
Navigation in the MPS450
Press the MODE key (the yellow key located on the keypad near the bottom of the unit)
to enable either the menu-control or numeric-control mode. The control mode can be
switched at any time, except while viewing current parameters on a VIEW page; press
the VIEW key to exit back to the mode you were in previously.
Action in the Menu-Control Mode
1. To navigate in menu-control mode, press the top-menu key for a function group,
labeled in yellow just above the corresponding number key. (Available functions in
each of the menu categories are listed in the “Using the MPS450” section earlier in
this chapter.)
2. Press one of the four function keys (the blue keys located on the keypad just beneath
the LCD) to select from options displayed on the screen.
3. To scroll through screens while in the menu mode, select PREV or NEXT. (Selecting
PREV from the first selection—or NEXT from the last selection—in a menu usually
results in a double-beep. Press the ESC key to return to the previous menu, or press
another top-menu key.)
4. To scroll through the adjustment options, select DOWN or UP.
5. Some menu selections are active when displayed. For others, RUN must be selected
to execute the option. (Instructions are provided in this manual for each function.)
When selected, RUN or RUNNING flashes on the LCD screen to indicate the
selection is active.