Fluke Biomedical MPS450 - Manual (Page 26)

MPS450
Operators Manual
1-12
Setting the MPS450 View Angle
The MPS450 offers eight preconfigured settings to customize the preferred degree of
contrast (brightness) for the angle at which the LCD screen is being viewed.
Action in the Menu-Control Mode
1. Press the top-menu key labeled SETUP to display the LCD screen:
gje007.eps
2. Select VIEW to scroll to the LCD screen SET VIEW ANGLE, which displays the
current screen-contrast setting (in this example, 4):
gje008.eps
3. To adjust the LCD screen’s contrast, scroll to the preferred setting, from 1 (lowest) to
8 (highest). The setting is active when displayed and remains active until the setting
is changed.
4. To store the contrast setting beyond the current session, select STORE. On the LCD
screen, Storing blinks on momentarily to indicate the value is being saved.
5. Press the ESC key to return to the top menu SETUP.
Adjusting the MPS450 Beeper
If not turned off, the MPS450 beeper sounds on power-up and whenever a key is pressed.
A double-beep sounds for an invalid key.
The MPS450 offers three preconfigured settings to customize the beeper sound: off,
short, or long.
Action in the Menu-Control Mode
1. Press the top-menu key labeled SETUP to display the LCD screen.
2. Select > to display the following LCD screen: