Flowserve 400MD Logix - Manual (Page 77)

Parameter Name Bit or Byte Values Description
ACT_SIZE 86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
105
Fisher 657-46
Fisher 657-50
Fisher 657-60
Fisher 657-70
Fisher 657-80
Fisher 657-87
Fisher 657-100
Fisher 667-30
Fisher 667-34
Fisher 667-40
Fisher 667-45
Fisher 667-46
Fisher 667-50
Fisher 667-60
Fisher 667-70
Fisher 667-80
fisher 667-87
Fisher 667-100
Other
SPRING_TYPE 0
1
2
3
4
5
99
88
USER_INTERFACE_INSTANT Bit 0 0x0001
Bit 1 0x0002
Bit 2 0x0004
Bit 3 0x0008
Bit 4 0x0010
Bit 5 0x0020
Bit 6 0x0040
Bit 7 0x0080
Bit 8 0x0100
Bit 9 0x0200
Bit 10 0x0400
Bit 11 0x0800
Bit 12 0x1000
Bit 13 0x2000
Bit 14 0x4000
Bit 15 0x8000
Air Action ATO Enabled
Characterization Linear
Auto Tune Enabled
Low Friction Mode
Calibration Auto
DIP SW 6 Spare
Up Button Not Pressed
DN Button Not Pressed
Bit 1 of Gain Selector
Bit 2 of Gain Slelector
Bit 3 of Gain Selector
For Future Use
Quick Cal Button Not Pressed
For Future Use
For Future Use
For Future Use
9 Calibration
9.1 Introduction
This section provides information about calibrating the Logix 3400MD digital positioner’s sensors.
9.2 Overview
About Calibration
When re-calibration is required, the Logix 3400MD digital positioner does not need to be removed from the process and may be calibrated in
the field.
NOTE: Calibration will cause the valve to fully stroke, so calibration must not be initiated while the valve is on line in the process.
Logix 3400MD Digital Positioner LGENIM3405-02 11/13
77