DR Power 16.50 Pro User Manual
Page 62
58
16.50 PRO DR
®
RAPID-FEED™ CHIPPER
7. Attach both Light Brackets to the Frame with Bolts and
Locknuts with two 1/2" wrenches (Figure 66).
8. Secure the Wires under the Frame with Cable Ties at
the four places shown (Figure 67).
9. Pull the excess wire to the front of the Chipper.
10. Strip 1" of insulation from the end of the White
(Ground) Wire.
11. Loosen a Trailer Hitch Bolt, wrap the White (Ground )
Wire around the Bolt, and then re-tighten with two
3/4" wrenches (Figure 68).
12. Roll up the extra wire and wire tie it to the Tow Bar.
NOTE: We recommend that you wrap the Harness Wires together
with electrical tape about every twelve inches starting at the Wire
Harness Connector end and going back to where the wires go to
either side of the Frame.
Light
Bracket
Figure 66
Bolt and
Locknut
Ground
Wire
Figure 68
Cable Tie
Excess Wire
to Tow Bar
Trailer
Hitch Bolt
Wire Harness
Figure 67
Cable
Ties