DR Power 16.50 Pro - Manual (Page 55)

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 51
CHAPTER 7
CHIPPER ACCESSORIES
Extended Top-Discharge Chute
The Extended Top-Discharge Chute enables you to better control the direction of the discharged chips
and allows you to direct them into a trailer or truck bed for transport.
Tools Needed:
• Two 1/2" Wrenches
INSTALLATION
1. Remove the two Bolts and Locknuts from the Low
Discharge Assembly with two 1/2" wrenches (Figure
47).
2. Remove the Low Discharge Assembly from the
Chipper.
3. Position the Extended Top-Discharge Chute onto the
Chipper with the Locking pin on the outside (side
furthest away from the hopper) (Figure 48).
4. Install the two Bolts and Locknuts and tighten with
two 1/2" wrenches.
Low
Discharge
Assembly
Figure 47
Bolt and
Locknut
Extended Top-
Discharge Chute
Figure 48
Locking
Pin
Bolt and
Locknut
(2 places)
SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE, ADDING OPTIONAL ACCESSORIES OR INSPECTION
ON THE CHIPPER.