beautypg.com

DR Power 16.50 Pro User Manual

Page 32

background image

28

16.50 PRO DR

®

RAPID-FEED™ CHIPPER

To Free a Jammed Flywheel

Tools Needed:

• Two 1/2" Wrenches

Disassemble:

1. Disconnect the battery at the negative terminal.

2. Remove any material left in the Chipper Hopper.

3. Remove the two Bolts and Locknuts that secure the

Discharge Chute to the Chipper Basic Assembly with
two 1/2" wrenches and then remove the Discharge
Chute (Figure 23).

4. Check to see if the Discharge Chute or Discharge

opening is clogged. If it is, clear it with a branch.

5. With a wooden stick, loosen and remove any material

left in the Chipping Chamber and make sure the
Flywheel turns freely with the stick.

Reassemble:

1. Position the Discharge Chute onto the Chipper Basic Assembly and secure with two Bolts and

Locknuts using two 1/2" wrenches.

2. Reconnect the battery negative terminal cable, the spark plug wire and start the Chipper engine;

allowing the remaining material in the Chipping Chamber to discharge.

3. If the Chipping Chamber doesn’t clear and the flywheel is still jammed, repeat above process.

NOTE: Be certain the Chipping Chamber is clear before trying to process more material into the Chipper

Hopper.

Figure 23

Discharge
Chute

Bolts and
Locknuts

Scroll
Weldment

NEVER PRY AGAINST THE SCROLL WELDMENT WHEN REMOVING THE DEFLECTOR OR DISCHARGE
CHUTE, OR AT ANY OTHER TIME. THIS WILL CAUSE DAMAGE TO THE MACHINE.

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,
REMOVE SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5
MINUTES BEFORE MOVING OR WORKING ON THE CHIPPER.

This manual is related to the following products: