Attaching the hopper assembly, Attaching the discharge chute, Attaching the hitch plate – DR Power 16.50 Pro User Manual
Page 20
16
16.50 PRO DR
®
RAPID-FEED™ CHIPPER
Attaching the Hopper Assembly
NOTE: We recommend that you have someone help you lift the
Hopper in place and support it until it is secured to the Chipper.
Tools Needed:
• Two 1/2" Wrenches
1. Attach the Hopper Assembly to the Chipper with six
5/16"-18 x 1" Bolts, twelve Flat Washers (one Washer
on Bolt side and one on Lock Nut side) and six Nylon
Lock Nuts (Figure 7).
NOTE: Install hardware with Bolt Head on the top side.
Attaching the Discharge Chute
Tools Needed:
• Two 1/2" Wrenches
1. Position the Discharge Chute as shown and secure
with two 5/16-18 x 5-1/4" Bolts and Nylon Locknuts
(Figure 8).
Attaching the Hitch Plate
Tools Needed:
• Two 1/2" Wrenches
1. Position the Hitch Plate onto the Tongue Assembly as
shown and secure with two 5/16-18 x 1" Bolts and
Nylon Locknuts (Figure 9).
Hopper
Hardware
Hopper
Assembly
Figure 7
Figure 8
Discharge
Chute
Bolts and
Locknuts
Tongue
Assembly
Hardware
Hitch
Plate
Figure 9