DR Power 16.50 Pro - Manual (Page 29)

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 25
Starting the Engine (Electric–Starting Chipper)
1. Ensure that the Fuel Shut-Off Valve is in the “ON”
position (Figure 14).
2. Move the Choke Control Lever to the “CHOKE”
position (Figure 19) (leave in the RUN position if the
engine is already warm).
3. Ensure that the Throttle Control Lever is in the slow
position (turtle icon) (Figure 20).
4. Insert the Key into the Key Switch and turn the Key to
the “START” position until the engine starts, then
release it (Figure 21). The Key Switch will snap back
to the “RUN” position and the engine will continue to
run.
5. As the engine warms up, slowly adjust the Choke to
the “Run” position. Wait until the engine runs
smoothly before each Choke adjustment. For
chipping, operate the engine with the Throttle in the
fast position (rabbit icon) with the Choke pushed in to
the “RUN” position.
Choke
Control
Lever
Figure 19
“RUN” “CHOKE”
Throttle
Control
Lever
Figure 20
Slow Fast
Figure 21
Key Switch
“STOP”
“START”
“RUN”