DR Power RapidFire Premier Yard Tow Kit (August 2014 - Present) - Manual

CONTACT US AT www.DRpower.com 1
DR ®
PREMIER RAPIDFIRE™ LOG SPLITTER
Yard Tow Kit# 35171
These instructions are for installation of the Yard Tow Kit. Please keep these instructions with your Safety and Operating
Instructions manual for future reference. The DR Premier Rapidfire Log Splitter is not designed to be towed on roads.
Parts Supplied ( Figure 1):
Item # Part # Description Qty
1 .................... 34502 ............ Stand, Jack ...................................................... 1
2 .................... 32102 ............ Tow-bar .......................................................... 1
3 .................... 18737 ............ Pin, Clevis, 1/2" OD X 4.5" LG ...................... 3
4 .................... 16003 ............ Pin, Hair, 1/2" To 9/16", .12" Wire ............... 3
5 .................... 33353 ............ Bolt, Hex, Flange, 1/2-13 X 4" ....................... 1
6 .................... 33348 ............ Bolt, Hex, Flange, 3/8-16 X 2.5" .................... 4*
7 .................... 33335 ............ Nut, Nylon Lock Flanged, 1/2-13 .................. 1
8 .................... 33333 ............ Nut, Nylon Lock Flanged, 3/8-16 .................. 4
Not shown .... 34517 ............ Bolt, Hex, Flange, 3/8-16 X 3.5" .................... 2**
*Two needed for install with carriages. Four needed for install with Tray.
**Needed when install with Carriages.
Compare the contents of the Shipping Box with the “Parts Supplied” list above.
If you have any questions please contact us at www.DRpower.com or call 1-800-
DR-OWNER (376-9637) for assistance.
Tools needed:
 Jack Stand

Two 9/16" Wrenches
Installing with Carriages
1. Remove the Bolts (item # 6) and Locknuts (item #8) from the Tow Bar
(Figure 1).
2. Support the Beam with a Jack Stand or equivalent to hold the Beam up
(Figure 2).
3. Remove the Support Leg if one is already installed using a 9/16" Wrench.
4. Remove the two front Bolts, Saddle Washers and Locknuts from the
Carriages using two 9/16" Wrenches.
5. Install the two 3.5" Bolts from the Kit with the original Saddle Washer and
new Locknuts through the Carriage, Beam and Tow-Bar. Tighten with two
9/16" Wrenches.
6. Install two 2.5" Bolts (item # 6) and Locknuts (item #8) through the Beam
and Tow-Bar and tighten using two 9/16" Wrenches.
Tow
Hitch
Figure 2
2.5" Bolt with
Locknut
3.5" Bolt with
Saddle Washer
and Locknut
Jack Stand
Cradle
Figure 1
4
1
6
2
3
5 7
8
Before performing this kit installation, stop the engine, wait five minutes to
allow all parts to cool. Disconnect the spark plug wire, keeping it away from
the spark plug.