beautypg.com

Removing and replacing the engine oil, Removing, replacing and adjusting the drive belt – DR Power 16.50 Pro User Manual

Page 35

background image

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 31

Removing and Replacing the Engine Oil

Tools and Supplies Needed

• SAE 30 HD Oil

• Oil Filter Wrench

• 5/8" Wrench

• Suitable container for used oil

• Rags

NOTE: Drain the oil when the engine is warm. Warm oil

drains quicker and more completely.

1. Position a suitable oil receptacle under the engine oil

Drain Plug and remove the engine oil Fill Cap.

2. Remove the Oil Drain Plug from the Oil Drain Elbow

with a 5/8" wrench (Figure 25). Allow the used oil to
drain completely, and then replace the Oil Drain Plug.

3. Replace the engine oil using SAE 30 HD oil (see

“Adding Engine Oil and Gasoline” in Chapter 3 for
instructions on adding oil).

4. Reattach the spark plug wire.

NOTE: Be sure to use environmentally safe disposal

procedures in the disposing of the used oil.

Removing, Replacing and Adjusting the Drive Belt

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.

Oil Drain
Elbow
and Plug

Figure 25

Dipstick

USE ONLY DR BELTS ON YOUR MACHINE. THE BELTS HAVE BEEN THOROUGHLY TESTED AND
PROVEN FOR MANY HOURS OF USE.

SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE CHIPPER.

This manual is related to the following products: