beautypg.com

DR Power 16.50 Pro User Manual

Page 19

background image

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 15

1. Cut the Plastic Banding that is securing the Parts Box

and any Accessory Box that may be strapped to the
Crate Top (Figure 5).

2. Pry off the bottom four boards that connect the Crate

top to the Pallet.

3. With help from another person, lift the Crate Top

from the Pallet.

4. Remove the Parts Box and the Road-Tow Package (if

ordered).

5. Carefully cut the Steel banding holding the machine

and Hopper Assembly to the pallet (Figure 6).

6. Cut the Plastic Banding that is holding the Extended

Top-Discharge Chute (if ordered) to the Pallet and
remove the Extended Top-Discharge Chute.

7. With the help of another person, carefully remove the

Hopper Assembly and roll the 16.50 PRO DR RAPID-
FEED CHIPPER from the shipping pallet, resting it on
the Tongue Assembly.

8. Compare the contents of the shipping carton and the

Part Box with the Parts Supplied list on the previous
page. If there are any questions contact us at
www.DRpower.com or call 1-800-DR-OWNER (376-
9637).
Do not discard the shipping materials until
you are fully satisfied with your new 16.50 PREMIER
DR RAPID-FEED CHIPPER.

Plastic
Banding

Bottom
Board

Figure 5

Pallet

Crate Top

WEAR EYE PROTECTION WHEN CUTTING THE BANDING. THE BANDING MAY HAVE A LOT OF

TENSION ON IT AND MAY SNAP AND CUT YOU. ALWAYS STAND TO ONE SIDE WHEN CUTTING
THE BAND.

STABILIZE THE SHIPPING CONTAINER ON CLEAN FLAT TERRAIN BEFORE ATTEMPTING TO

UNPACK AND ASSEMBLE THE CHIPPER.

FOR YOUR SAFETY WE RECOMMEND YOU HAVE TWO PEOPLE FOR THE FOLLOWING

PROCEDURES.

Steel
Banding

Plastic
Banding

Figure 6

Chipper
Assembly

Hopper
Assembly

Steel
Banding

This manual is related to the following products: