beautypg.com

Adjusting the angle of the tongue weldment – DR Power 16.50 Pro User Manual

Page 31

background image

CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 27

Adjusting the Angle of the Tongue Weldment

The Tongue Weldment can be adjusted to the horizontal
position to enable the Chipper to be towed with a tractor or
it can be adjusted to the vertical position as a Support Leg
to level and stabilize the Chipper when not hitched to a
tractor.

1. Support the front of the Base Frame with a Jack Stand

or Blocks (make sure you are off to the side of the
Tongue Weldment so it can rotate freely).

2. Pull the Hitch Clip from the Pin and remove the Pin

(Figure 22).

3. Rotate the Tongue Weldment to the vertical (support

leg) position and reinsert the Pin into the Pin Holes for
the Support Leg position.

4. Secure the Pin by inserting the Hitch Clip.

5. Reverse these procedures to Adjust to the Towing

position (non-highway) and your Chipper is now ready
to hitch to your tractor.

Pin Holes for
Towing Position

Pivot

Tongue
Weldment

Figure 22

Pin Holes for
Support Leg
Position

Support Leg
Position

Towing
Position

Pin and
Hitch Clip

AVOID DEATH OR SERIOUS INJURY. DO NOT TOW THIS MACHINE FASTER THAN 10 MPH. THIS
MACHINE IS NOT LEGAL FOR STREET OR HIGHWAY USE UNLESS YOU INSTALL THE ROAD-
TOWING PACKAGE (SEE “CHIPPER ACCESSORIES” IN CHAPTER 7).

This manual is related to the following products: