DR Power 16.50 Pro - Manual (Page 28)

24 16.50 PRO DR ® RAPID-FEED™ CHIPPER
Starting the Engine (Manual –Starting Chipper)
1. Ensure that the Fuel Shut-Off Valve is in the “ON”
position (Figure 14).
2. Move the Choke Control Lever to the “CHOKE”
position (Figure 16) (leave in the RUN position if the
engine is already warm).
3. Move the Throttle Control Lever to about half way
between Slow and Fast position (Figure 17).
4. Push the On/Off Toggle Switch to “Start” and slowly
pull the Starter Cord until you feel resistance, then pull
quickly (Figure 18). The Cord will recoil back into
position.
5. As the engine warms up, slowly adjust the Choke to
the “Run” position (Figure 16). Wait until the engine
runs smoothly before each Choke adjustment.
6. When the Engine is warmed up and running smoothly
with the Choke in the “RUN” position, move the
Throttle Control Lever to the fast position (rabbit icon)
for chipping.
On/Off
Toggle Switch
Figure 18
Starter
Cord
Choke
Control
Lever
Figure 16
“RUN” “CHOKE”
Throttle
Control
Lever
Figure 17
Slow Fast