DR Power 16.50 Pro - Manual (Page 60)

56 16.50 PRO DR ® RAPID-FEED™ CHIPPER
11. Slide a Wheel Assembly onto the Axle Shaft. Make
sure the open side of the Wheel Hub with the loose
Taper Bearing is facing towards you (Figure 60).
12. Screw the Castle Nut onto the Axle and tighten it with
an adjustable wrench to seat the Bearings (Figure 61).
13. Back the Castle Nut off and then snug it up to the
Bearing lightly.
14. Insert a Cotter Pin through the slots of the Castle Nut
and into the hole in the Axle.
15. Bend the ends of the Cotter Pin with Needle nose
Pliers to secure it.
16. Place the Dust Cap onto the Wheel Assembly and
secure it by placing a piece of wood over it and
pounding lightly with a hammer until it is against the
lip (Figure 62).
17. Jack the back of the Chipper up and remove the jack
Stands.
18. Lower the Chipper to the ground.
19. Check the Tire for proper air pressure of 60 psi
maximum in each Tire.
Figure 60
Wheel
Assembly
Taper
Bearing
Figure 61
Castle
Nut
Cotter Pin
Figure 62
Wheel
Assembly
Dust Cap