DFI AM636-B User Manual

Page 76

BIOS Setup

Soft-Off by PWRBTN

This field allows you to select the method of powering off your system.

Delay 4 Sec.
Regardless of whether the Power Management function is enabled or disabled,
if the power button is pushed and released in less than 4 sec, the system en-
ters the Suspend mode. The purpose of this function is to prevent the system
from powering off in case you accidentally “hit” or pushed the power button.
Push and release again in less than 4 sec to restore. Pushing the power but-
ton for more than 4 seconds will power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately power
off your system.

PowerOn By PCI Card

Enabled
This field should be set to Enabled only if your PCI card such as LAN card or
modem card uses the PCI PME (Power Management Event) signal to remotely
wake up the system. Access to the LAN card or PCI card will cause the sys-
tem to wake up. Refer to the card’s documentation for more information.
Disabled
The system will not wake up despite access to the PCI card.

ACPI XSDT Table

Enable the ACPI XSDT table only when using a 64-bit mode OS. The table does
not support 32-bit mode OS such as Windows 2000 and Windows XP.

HPET Support

The options are Enabled and Disabled.

Power On Function

This field allows you to use the PS/2 keyboard or PS/2 mouse to power-on the
system.

Button only
Default setting. Uses the power button to power on the system.
Password
When this option is selected, set the password you would like to use to pow-
er-on the system in the “KB Power On Password” field.
Hot Key
When this option is selected, select the function key you would like to use to
power-on the system in the “Hot Key Power On” field.
MS Move&Click
When this option is selected, move/click the mouse to power-on the system.