Datatek DT-4180 - Manual (Page 53)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
53
[ x25pass=< OFF | DFLT | “Password String” > ]
[ x25xid=< XID Link ID > ]
vc= [ vcsvc=< PAD | PASS | ISO
RBP | MAC | SESS> ]
[ vcckt=< SVC | PVC > ]
[ vcwin= ]
[ vcpkt=< 128 | 256 | 512 | 1024 > ]
[ pvcreset=< ON | OFF > ]
[ pvcrstlnk=< OFF | CONSTDCD | SWDCD >]
[ svctclass=< NONE | Throughput > ]
[ padecho=< ON | OFF > ]
[ paderase=< NONE | BS | ]
[ padidle=< #X.3 Ticks > ]
[ padbreak=< NONE | INTR |
RESET | BRKIND > ]
[ padparity=< TRANS | EVEN | ODD >]
[ padcrlf=]
[ padfwd= SEMI | ALL | GRPx > ]
[ padcmap=< ON | OFF > ]
[ padapi=< RAW | TELNET > ]
[ PADCUG=[+|-] ]
[ calling=< DNIC+NTN > ]
[ called=< DNIC+NTN > ]
[ ulen=< UData Length >]
[ udata#=< HEX BYTE >]
[ ext_calling=< OSI NSAP >]
[ ext_called=< OSI NSAP >]
[ hport=]
[
vccom=”User Comment” ]
This command configures an individual user port. The parameter is a
number in the range of 1 through the N that corresponds to the RS-232C user port being
configured. The value N is one for the 9480, four for the 4284, sixteen for the 4000XA
and 4180, and thirty-two for the 4280.
When a port uses TCP/IP for communications, it is either a port which waits for an
incoming call (type=rcv), or an originator of a call (type=orig). The (optional) PDD for
an orig-type port is defined by dest= and dport=. A caller on an
originating port without PDD information configured will be presented a xxxx
Destination> prompt for “dialing”.
A port with (
type=x25 ) is internally connected to a corresponding instance of the
X25PAD application. One or more of the various X25PAD feature packages is required
for this option. The X.25 options then become available for this port. The virtual circuits
for the X.25 ports will default to a TCP port number of 30,000 for the 1
st port plus the