Datatek DT-4180 - Manual (Page 52)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
52
6.2 USER PORT COMMANDS
The User Port commands are used to configure the operation of the individual RS-232C
ports on the xxxx. The ports are endpoints on an IP infrastructure. They may be
configured to originate or receive connections by the commands in this section. When
used with a “built in” X.25 mediation interface, the connectivity configuration is not
required.
6.2.1 PORT
Syntax: port < PortNum > [ type = ]
[ pdd = < PDD DNS destination address >]
[ dest = < ipaddr > ]
[ dport = ]
[ hport = ]
[ peer = ]
[ prot = < protocol > ]
[ dxe = < dce | dte > ]
[ clk = < norm | rcvd > ]
[ phy = < 232 | v35 | 530 > ]
[ baud = < baud rate > ]
[ enc = < nrz | nrzi > ]
[ ccar = < on | off > ]
[ swcar = ]
[ pap = < on | off > ]
[ fill = < mark > | < flag > ]
[ dbits = < 5 | 6 | 7 | 8 > ]
[ parity = < even | odd | none > ]
[ stop = < 1 | 1.5 | 2 ]
[ attn = < 1brk | 2brk | none | char > ]
[ flow = < xon | hw | none > ]
[ cug = [+ | - ] < cug num > ]
[ crfix = < trans | nonnull > ]
[ crlf = < trans | nolf > ]
[ PDDonCR = < on | off > ]
[ crypt = < on | off > ]
[ loopback = < OFF | NET | PORT | BOTH > ]
[ comment = ”user comment” ]
[ moveto= ]
[ copyto= ]
[ x25dxe=< DTE | DCE > ]
[ x25win= ]
[ x25t1=< LAPB T1 Timer >]
[ x25n2=< LAPB N2 Retry Counter > ]
[ x25dar=< ON | OFF > ]