Datatek DT-4180 - Manual (Page 51)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
51
DSTAT General User
GATEWAY Level 4 Administrator
HELP General User
HOST Level 3 Administrator
INSTALL General User
LABEL Level 4 Administrator
LOCAL Level 4 Administrator
LOGOUT General User
MAP General User
PING Level 1 Administrator
PORT Level 2 Administrator
REBOOT Level 4 Administrator
REMOVE (mod) Level 4 Administrator
REMOVE (port) Level 2 Administrator
REMOVE (IP-GATE) Level 2 Administrator
REMOVE (TSR) Level 2 Administrator
RESTORE (mod) Level 4 Administrator
RESTORE (port) Level 2 Administrator
RESTORE (IP-GATE) Level 2 Administrator
RESTORE (TSR) Level 2 Administrator
RSTPASS General User
SAMEXT Level 2 Administrator
SNMP Level 3 Administrator
SNOOP General User
TIMEOUT Level 4 Administrator
TSR Level 2 Administrator
VER General User
UPROMPT Level 3 Administrator
VFY General User
Please note that if multiple administrators have the same password, the lowest value is
used. It is recommended that passwords be unique.
6.1.34 eSAM Board Configuration
The xxxx may be configured to operate as a network extended board from a eSAM.
This configuration is used in conjunction with BNS and Datakit networks as a method to
provide BNS native mode operation while traversing an IP infrastructure.
The xxxx is configured as a eSAM extension board with a single command samext
without arguments. It will prompt for a level 2 password as confirmation to proceed with
the configuration. The samext command will configure all the ports on the xxxx to act as
eSAM extended ports and restore them to service. The eSAM will subsequently make a
TCP connection on a per port basis and declare the board inserted when all of the
connections have completed. Prior to using the samext command, all of the ports on the
xxxx need to be removed from service.