Datatek DT-4180 - Manual (Page 25)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
25
Each 9116 port has 15 LED indicators. These are described as follows:
Lamp Function
RxD
DB25 Receive Data indication.
TxD DB25 Transmit Data indication.
DCD DB25 Data Carrier Detect indication.
CTS DB25 Clear to Send indication.
DSR DB25 Data Set Ready indication.
RTS DB25 Request to Send indication.
DTR DB25 Data Terminal Ready indication.
CLK DB25 RxC and TxC indication.
SCTE DB25 External Timing indication.
SYNC Port is operating in synchronous mode.
Asynchronous mode when not illuminated.
DCE Port is operating in logical DCE mode.
Logical DTE mode selected when not illuminated.
V.11/V.35 Port is operating in V.11 or V.35 mode.
RS-232 mode when both V.11/V.35 and RS-530(A) lamps are
extinguished.
RS-530(A) Port is operating in RS-530 or RS-530(A) modes.
RS-232 mode when both V.11/V.35 and RS-530(A) lamps are
extinguished.
Status 9116 IPP port reporting status information to the xxxx.
Configure The xxxx is actively configuring the 9116 port.
The 9116 is also available in a single port version called the 9116-S. This is shown
below.
The single port version of 9116 has all of the features and automatic configuration but no
LED displays. The convenient size requires no rack space and converts the RJ45 to
DB25 directly. If a Winchester-34 cable is required, a Black Box FA058 or FA059 DB25
to Winchester-34 adapter is attached to the 9116.