Daktronics GPR-12EV-RGB - Manual (Page 64)

38 International Installation
Terminating hot, neutral, and ground wires at the J box
1. Route the power cable through 3 /
4
" conduit to the rear of the display and into the power
termination J box.
2. The power termination enclosure contains two wires plus a ground wire coming from
the interior of the display. These wires are pre-terminated to the power termination panel
inside the display.
3. Inside the external power
termination J box, connect the power
wires to the wires coming from the
display interior using wire nuts.
Refer to Figure 34 for a diagram.
Note the following colors are used for
the pre-terminated wires:
Figure 34: 240 VAC International Power Termination
240 VAC (two wires plus ground)
Line 1 Brown
Neutral Blue
Ground Green-Yellow