Daktronics GPR-12EV-RGB - Manual (Page 20)

14 Start-up Procedure
5.2 Start-up Sequence
Each time the display is turned on, an initialization sequence runs. Examples of the
information shown on the display are listed in the second column.
Attribute and Description Example
Current Firmware Version Running on Display M4-GalaxyProRev 4.X.X
Current Root File System Version Running on Display Rfs X.X.X
Display Size Row x Column
Display Color Type
Bit Depth of Display
RGB
32
Currently Configured Time Zone America/North Dakota/Center
Current IP Address of Display (see note below) Will vary
Name of Web Service and Port It Currently Runs On
Srvc: DisplayConfig
Port: 4500
Name of Web Service and Port It Currently Runs On
Srvc: DisplayStatus
Port: 4501
Name of Web Service and Port It Currently Runs On
Srvc: PlayerControl
Port: 4502
Name of Web Service and Port It Currently Runs On
Srvc: SecurityManagement
Port: 4503
Name of Web Service and Port It Currently Runs On
Srvc: FileTransfer
Port: 4504
Name of Connected Sensor and Its Offset (Address)
Sensor: TEMP
Offset: Addr: 1
Name of Connected Sensor and Its Offset (Address)
Sensor: LIGHT_LUX
Offset: Addr: 2
User-Defined Display Description East Employee Entrance
Note: There are two Ethernet ports – Port 0 on the top and Port 1 on the bottom. Using Port 1
is preferred. During the start-up sequence, each port returns its status. When a port is not
used, the display will show “not found”. The port that is used returns the IP address.
The order of services and sensors could change. After this sequence is complete, the display
will blank. A single pixel will flash in the lower-right corner of the display to show that the
display has power, but no presentations are currently running.
5.3 Post Installation Checklist
Verify the following after starting the display:
• Assure all ventilation fans are fully operational.
• Inspect all intake and exhaust vents for obstruction.
• Confirm proper communications from the control computer to the display(s).
• Assure proper communications between display faces when applicable.