Comtech EF Data MBT-4000B - Manual (Page 49)

Multi-Band Transceiver System Revision 0
Remote Command MN/MBT4000B.IOM
A-13
Parameter
Type
Command
(Instruction
Code and
qualifier)
Valid on
MBT,
BDC, or
BUC
Arguments for
Command or
Response to
Query
Description of arguments
(Note that all arguments are ASCII numeric codes, that is,
ASCII codes
between 48 and 57)
Response to
Command
(target to
controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
Circuit
Identification
CID= All 24 bytes,
alphanumeric
Command or Query.
Used to identify or name the unit or station. First line is limited to 24
characters.
Example: CID={cr}
-Earth Station 1--
---Converter #1--- CID=(message
ok)
CID?(received ok,
but invalid
arguments found) CID? CID=x…x
(see
description for
details of
arguments)
Calibrate
LNA Current
CLC=s MBT
BDC
S=1 byte
Value of
1 , 2
1=LNA A
2= LNB bias
tee
Command only.
This command is used to set the calibration point for the LNA /LNB
current alarm feature.
Source
1=LNA A (AUX COMM1)
2=LNB Bias Tee
Example: CLC=2 would record the current measured for the LNB
bias tee CLC=(message
ok)
CLC?(received
ok, but invalid
arguments found)
CLC*(message
ok, but not
permitted in
current mode)
CLC!(command
not accepted by
BUC or BDC sub-
units.) N/A N/A