Comtech EF Data SMS-758 - Manual (Page 162)

Remote Control Operation SMS-758 Modem Protection Switch
B–18 MN/SMS758 Rev. 3
B.3.5.8.5 Bulk Consolidated Status Faults
This command causes all switch fault status to be returned. To reduce the length of the
response, fault status is embedded into the bit structure of the characters that are
returned. Faults are indicated by a binary 1 in the designated bit position.
Command:
Response: >add/BCSF_”a””b””c”...”x””y””z””aa””ab””ac””ad””ae””cr””lf”]
Character “a”: Modulator fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modulator #1 fault.
Bit 4 = Prime modulator #2 fault.
Bit 3 = Prime modulator #3 fault.
Bit 2 = Prime modulator #4 fault.
Bit 1 = Prime modulator #5 fault.
Bit 0 = Prime modulator #6 fault.
Character “b”: Modulator fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime modulator #7 fault.
Bit 4 = Prime modulator #8 fault.
Bit 3 = Backup modulator #1 fault.
Bit 2 = Backup modulator #2 fault.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character “c”: Demodulator fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime demodulator #1 fault.
Bit 4 = Prime demodulator #2 fault.
Bit 3 = Prime demodulator #3 fault.
Bit 2 = Prime demodulator #4 fault.
Bit 1 = Prime demodulator #5 fault.
Bit 0 = Prime demodulator #6 fault.
Character “d”: Demodulator fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime demodulator #7 fault.
Bit 4 = Prime demodulator #8 fault.
Bit 3 = Backup demodulator #1 fault.
Bit 2 = Backup demodulator #2 fault.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character “e”: Modulator operational fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modulator #1 backup operational fault.
Bit 4 = Prime modulator #2 backup operational fault.
Bit 3 = Prime modulator #3 backup operational fault.
Bit 2 = Prime modulator #4 backup operational fault.
Bit 1 = Prime modulator #5 backup operational fault.
Bit 0 = Prime modulator #6 backup operational fault.