A.3.4.1.2 backup modulator configuration status, A.3.4.1.3 prime demodulator configuration status, A.3.4.1.4 backup demodulator configuration status – Comtech EF Data SMS-758 User Manual
Page 130

Remote Control Operation
SMS-758 Modem Protection Switch
A–8
MN/SMS758 Rev. 3
A.3.4.1.2 Backup Modulator Configuration Status
The Backup Modulator Configuration Status command causes a block of data to be
returned by the SMS-758. The block of data reflects the stored configuration of the
modulator selected.
Command:
Response: >add/MCS_Bx”cr” MA_yyy”cr” M od Active (YES/NO) ADD_yyy”cr” M odem Address INT_y”cr””lf”] M odem Interface Type Where: x = 1 or 2 (backup modem number). A.3.4.1.3 Prime Demodulator Configuration Status The Prime Demodulator Configuration Status command causes a block of data to be Command: Response: >add/DCS_x”cr” DA_yyy”cr” D emod Active (YES/NO) MP_y”cr” M odem Priority (1, 2, or 3) DT_y”cr” D emod Transponder MD_yyy.y”cr” M odem Delay ADD_yyy”cr” M odem Address INT_y”cr””lf”] M odem Interface Type Where: x = 1 to 8 (prime demodulator number). A.3.4.1.4 Backup Demodulator Configuration Status The Backup Demodulator Configuration Status command causes a block of data to be Command: Response: >add/DCS_Bx”cr” DA_yyy”cr” D emod Active (YES/NO) ADD_yyy”cr” M odem Address INT_y”cr””lf”] M odem Interface Type Where: x = 1 or 2 (backup demodulator number).
returned by the SMS-758. The block of data reflects the stored configuration of the
demodulator selected.
returned by the SMS-758. The block of data reflects the stored configuration of the
modulator selected.