Comtech EF Data SMS-758 - Manual (Page 127)

SMS-758 Modem Protection Switch Remote Control Operation
MN/SMS758 Rev. 3 A–5
A.3.2.2 Prime Demodulator Transponder
Command:
Response: >add/DT_x_y”cr””lf”]
Status Only:
Response: >add/DT_x_y”cr””lf”]
Where:
x = 1 to 8 (prime demodulator number).
y = 1, 2, 3, or 4 (transponder number, four transponders option).
y = 1, 2, 3, 4, 5, 6, or 7 (transponder number, seven transponders option).
Note: See the “DTO_” command for the definition of downlink transponder option.
A.3.2.3 Backup Demodulator Active
Command:
Response: >add/DA_Bx_yyy”cr””lf”]
Status Only:
Response: >add/DA_Bx_yyy”cr””lf”]
Where:
x = 1 or 2 (backup demodulator number).
yyy = YES or NO.
Note: Backup number 2 cannot be active if the downlink transponders option is specified
to be “7”. See the “DTO_” command.
A.3.3 Modem Configuration Commands/Responses
A.3.3.1 Prime Modem Address
Address “0” may be used to clear the address field of modem “x”.
Command:
Response: >add/ADD_x_yyy”cr””lf”]
Status Only:
Response: >add/ADD_x_yyy”cr””lf”]
Where:
x = 1 to 8 (prime modem number).
yyy = 1 to 255 (prime modem address).