Comtech EF Data SMS-758 - Manual (Page 137)

SMS-758 Modem Protection Switch Remote Control Operation
MN/SMS758 Rev. 3 A–15
A.3.5.7.3 M:N Switch Fault Status Summary
Command:
Response: >add/MNF_”cr”
COM_FLT_xxxxxxxxByBy”cr” Modem communications faults (see Note)
MOD_CONFIG_FLT_xxxxxxxxByBy”cr” Mod configuration verify faults (see Note)
DMD_CONFIG_FLT_xxxxxxxxByBy”cr” Demod configuration verify faults
(see Note)
MOD_COMPAT_FLT_xxxxxxxxByBy”cr” Mod compatibility fault (see Note)
DMD_COMPAT_FLT_xxxxxxxxByBy”cr” Demod compatibility fault (see Note)
+12V_FLT”cr” Power fault +12V (see Note)
-12V_FLT”cr” Power fault -12V (see Note)
+5V_FLT”cr” Power fault +5V (see Note)
PS1_FLT”cr” Powers supply #1 fault (see Note)
PS2_FLT”cr” Power supply #2 fault (see Note)
M&C_BAT_FLT”cr” M&C battery fault (see Note)
ADX_BAT_FLT”cr” Address Decoder/Driver battery fault
(see Note)
PARAMETER(S)_MISSING”cr””lf”] Missing parameter fault, use “MPF”
command to determine faults
(see Note)
Where:
x = 1 to 8 (prime modem number).
y = 1 or 2 (backup modem number).
Note: Fault status data is only returned if fault conditions exist.
A.3.5.7.4 Missing Parameter Faults
Command:
Response: >add/MPF_”cr”
NO_MOD_CONFIG_xxxxxxxxByBy”cr” No mod configuration loaded (see Note)
NO_DMD_CONFIG_xxxxxxxxByBy”cr” No demod configuration loaded (see Note)
NO_ADX_xxxxxxxxByBy”cr” No address specified for modem (see Note)
NO_INTFC_xxxxxxxxByBy”cr” No interface specified for modem
(see Note)
NO_DL_xxxxxxxx”cr””lf”] No downlink specified for demod (see
Note)
Where:
x = 1 to 8 (prime modem number).
y = 1 or 2 (backup modem number).
Note: Fault status data is only returned if fault conditions exist.