B.3.5.8.3 m:n switch fault status summary, B.3.5.8.4 missing parameter faults – Comtech EF Data SMS-758 User Manual
Page 161

SMS-758 Modem Protection Switch
Remote Control Operation
MN/SMS758 Rev. 3
B–17
B.3.5.8.3 M:N Switch Fault Status Summary
Command:
Response: >add/MNF_”cr” COM_FLT_xxxxxxxxByBy”cr” Modem communications faults (see Note) MOD_CONFIG_FLT_xxxxxxxxByBy”cr” Mod configuration verify faults (see Note) DMD_CONFIG_FLT_xxxxxxxxByBy”cr” Demod configuration verify faults (see Note) MOD_COMPAT_FLT_xxxxxxxxByBy”cr” Mod compatibility fault (see Note) DMD_COMPAT_FLT_xxxxxxxxByBy”cr” Demod compatibility fault (see Note) +12V_FLT”cr” power fault +12V (see Note) -12V_FLT”cr” power fault -12V (see Note) +5V_FLT”cr” power fault +5V (see Note) PS1_FLT”cr” power supply #1 fault (see Note) PS2_FLT”cr” power supply #2 fault (see Note) M&C_BAT_FLT”cr” M&C battery fault (see Note) PARAMETER(S)_MISSING”cr””lf”] Missing parameter fault; use “MPF” (see Note) Where: x = 1 to 8 (prime modem number). Note: Fault status data is only returned if fault conditions exist. B.3.5.8.4 Missing Parameter Faults Command: Response: >add/MPF_”cr” NO_MOD_CONFIG_xxxxxxxxByBy”cr” No mod configuration loaded (see Note) NO_DMD_CONFIG_xxxxxxxxByBy”cr” No demod configuration loaded (see Note) NO_ADX_xxxxxxxxByBy”cr” No address specified for modem (see Note) NO_INTFC_xxxxxxxxByBy”cr” No interface specified for modem (see Note) NO_DL_xxxxxxxx”cr””lf”] No downlink specified for demod (see Note) Where: x = 1 to 8 (prime modem number). Note: Fault status data is only returned if fault conditions exist.
command to determine faults
y = 1 or 2 (backup modem number).
y = 1 or 2 (backup modem number).