Comtech EF Data turboIP-45 - Manual (Page 99)

turboIP-45 Performance Enhancement Proxy Revision 0
Sample Configurations CD/TURBOIP45.IOM
7–3
7.3 Point-to-MultiPoint Configuration
In the Point-to-Multipoint configuration, a single turboIP-45 is used at the Hub to accelerate TCP traffic
to three Remote sites, each with a turboIP-45. The following table defines the configuration settings for
each turboIP-45.
Configuration Parameter Hub turboIP-45 Remote turboIP-45 (1, 2, & 3)
WAN Transmission Rate 45 Mbps (equal to the TX data
rate of Hub modem) 2048 kbps (equal to the TX data
rate of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration No Selective Acceleration Rules are required. Rules could be added
to prioritize or set BW limits on types of traffic. Rules could also be
added to set a priority or BW limit on traffic to a particular site.
Route Table No Route Table entries are required. Routes could be added to allow
remote access from outside of LAN subnet.