Comtech EF Data turboIP-45 - Manual (Page 38)

turboIP-45 Performance Enhancement Proxy Revision 0
Configuring turboIP-45™ CD/TURBOIP45.IOM
4–14
4.5 Menus and Functions - Summary
4.5.1 CLI Menu
Menu Description
Configure Interfaces Menu Enter Management IP Address and subnet mask
Turn WEB Interface On/Off
Turn SSH Interface On/Off
Set LAN/WAN port Link Setting
Display LAN/WAN MAC address and Link Status
Gateway Menu Set LAN and WAN Transmission Rates
Set WAN Maximum Transfer Unit (MTU)
Turn Compression On/Off
Set Congestion Control to Per-Connection or Rate Pacing
Routing Menu Add, adjust, or delete routes from system routing table
Route entries are only required for remote network access to the turboIP-45.
SNMP Menu Set SNMP subsystem On/Off
Set SNMP system variables such as, System Information, Community
Strings, and Trap Destination.
Selective Acceleration Menu Add, move, edit, and delete TCP/UDP QoS/Acceleration rules
Monitor statistics by priority
Each rule has the following variables - Source IP address/Mask, Destination
IP address/Mask, Protocol, Source Port, Destination Port, Priority,
Bandwidth, Acceleration ON/OFF, and Status.
Administration Menu Displays System Status for turboIP-45 features – easyConnect, FailToWre,
Event Logging, Compression, SNMP, Web Interface, SSH Interface
Displays System Up Time, turboIP-45 Version, Unit ID
Used to administer the system functions – Restore Defaults, Reboot,
Shutdown, Upgrade, Reset System Time, Change Password, Add User,
Delete User
Enable Logging, View or Clear Event Log
Display/Reset System Statistics – Avg. Compression Ratio, Session
Statistics, WAN and LAN Statistics