Comtech EF Data turboIP-45 - Manual (Page 28)

turboIP-45 Performance Enhancement Proxy Revision 0
Configuring turboIP-45™ CD/TURBOIP45.IOM
4–4
4.4.2 Configuration Wizard turboIP-45 - Summary
Note: At any time during the initial Configuration Wizard, the ESC key can be used to cancel
all changes and reboot.
Information to be provided throughout the Configuration Wizard is listed in the following table.
Detailed information is contained in the section listed.
Section Configuring
Item Default Value Format Example
4.4.2.1 Username
N/A Must be at least 5 and no more than 31 alphanumeric
characters in length. ‘admin’
Password N/A ‘C0mtech!’
4.4.2.2
Re-enter
password
N/A
Passwords must be at least 8 characters and no more
than 31 characters in length.
Passwords are case sensitive and must contain at least
one character from each of the following groups:
uppercase, lowercase, digit, and special character.
Special characters include
“_!-.;:<>,[]{}\|()*&^%$#@`~'+=?/”
‘C0mtech!’
UTC Month Two digit integer between 1 to 12 ‘01’
UTC Day Two digit integer between 1 to 30 or 31 ‘01’
UTC Year 4 digit integer ‘2006’
N/A
UTC Military
Time
Current system
setting
hh:mm:ss ‘09:19:51’
Management IP
Address 10.10.10.1 ddd.ddd.ddd.ddd ‘192.9.1.3’
Management
Subnet Mask 255.255.255.0 ddd.ddd.ddd.ddd ‘255.255.255.0’
4.4.2.3
Default
Gateway
0.0.0.0 ddd.ddd.ddd.ddd
Must be on same subnet as Management IP.
‘192.9.1.4’
4.4.2.4 WAN Rate
45 Mbps A number, followed by a space and 'bps', 'kbps' or 'Mbps'
Must be ≥ 10 kbps and ≤ 45 Mbps
‘1000 kbps’
4.4.2.5
DoD Warning
Banner
N/A 1 for Enable
2 for Disable
Selecting ‘Yes’ will enable the Department of Defense
warning banner on the Serial and SSH interfaces, which
will remain on the screen until the user hits a key on their
keyboard.
Note: The DoD Warning Banner can only be enabled or
disabled via the Configuration Wizard.
4.4.2.6 Web Interface
N/A 1 for Enable
2 for Disable
4.4.2.7
Configure
SNMP
N/A 1 for Enable
2 for Disable