Comtech EF Data turboIP-45 - Manual (Page 39)

turboIP-45 Performance Enhancement Proxy Revision 0
Configuring turboIP-45™ CD/TURBOIP45.IOM
4–15
4.5.2 WEB Menu
Menu Description
Acceleration Set LAN and WAN Transmission Rates
Set WAN Maximum Transfer Unit (MTU)
Turn Compression On/Off
Set Congestion Control to Per-Connection or Rate Pacing
Interface Enter Management IP Address and subnet mask
Set LAN/WAN port Link Setting
Display LAN/WAN MAC address and Link Status
Routes Add, adjust, or delete routes from system routing table
Route entries are only required for remote network access to the
turbo
IP-45.
Selective Acceleration
Rules
Stats
Add, move, edit, and delete TCP/UDP QoS/Acceleration rules
Monitor statistics by priority
Each rule has the following variables - Source IP address/Mask,
Destination IP address/Mask, Protocol, Source Port, Destination
Port, Priority, Bandwidth, Acceleration ON/OFF, and Status.
Administration Menu
Configuration
Event Log
Stats
Displays System Status for turboIP-45 features – easyConnect,
FailToWire, Event Logging, Compression, SNMP, SSH Interface
Displays System Up Time, turboIP-45 Version, Unit ID
Used to administer the system functions – Reboot, Shutdown,
Upgrade
Enable Logging, View or Clear Event Log
Display/Reset System Statistics – Avg. Compression Ratio, Session
Statistics, WAN and LAN Statistics
Note: The Web interface Administration menu does not support the
following functions - Restore Defaults, Changes to User Accounts or
Password, and Reset System Time. These functions are restricted to
the CLI or SSH serial interface.