Comtech EF Data turboIP-45 - Manual (Page 98)

turboIP-45 Performance Enhancement Proxy Revision 0
Sample Configurations CD/TURBOIP45.IOM
7–2
7.2 Point-to-Point Configuration
This configuration is a typical example where turboIP-45s are used to maximize the TCP throughput in
a Point-to-Point system. Note the turboIP-45s are placed so that all TCP traffic between the Remote and
the hub must pass through the turboIP-45. The following table defines the configuration settings for
each turboIP-45.
Configuration Parameter Hub turboIP-45 Remote turboIP-45
WAN Transmission Rate 45 Mbps (equal to the TX data
rate of Hub modem) 2048 kbps (equal to the TX data
rate of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration No Selective Acceleration Rules are required. Rules could be added
to prioritize or set BW limits on any type of traffic.
Route Table No Route Table entries are required. Routes could be added to allow
remote access from outside of LAN subnet.