Comtech EF Data turboIP-45 - Manual (Page 49)

turboIP-45 Performance Enhancement Proxy Revision 0
Configuring turboIP-45™ CD/TURBOIP45.IOM
4–25
4.5.11.2 Selective Acceleration Insert/Edit Rules Menu
Function Select Description
Source Address
Mask
1 or S Default 0.0.0.0 (wild card – applied to any IP address)
Source Address
Mask
2 or D Default 0.0.0.0 (wild card – applied to any IP address)
Priority 3 or P Select 1 – 8 (1 being highest priority)
Protocol 4 or R Select TCP, UDP or Any
Source Port
Start
End
5 Default __ (no entry = wild card – applied to any port)
Enter Start and End Port numbers for a range of ports.
Enter same port for Start and End for a single port.
Destination Port
Start
End
6 Default __ (no entry = wild card – applied to any port)
Enter Start and End Port numbers for a range of ports.
Enter same port for Start and End for a single port.
Maximum Bandwidth 7 or M Default 45000 kbps
Acceleration 8 or A Select On to accelerate TCP traffic within this Rule.
Select Off to bypass acceleration for TCP traffic within this Rule.
Status 9 or T Select Active for Rule to be applied.
Select Not in Service to have Rule not applied.