Comtech EF Data KST-12000 - Manual (Page 75)

Chapter 4. OPERATION
This chapter provides the following information:
• System operation
• Remote control
• Front panel display/keypad operation
4.1 System Operation
There are three methods of operating the RFT-1200:
• Connect a PC running DOS to the RS-232/485 remote control port, and run the
M&C system monitor software. This software is DOS-based and provides an
interface to the remote commands.
For information on the remote commands, refer to Appendix A.
For more information on the M&C system monitor program, refer to the Monitor
and Control Software for Comtech EF Data Satellite Terminals User’s Guide.
• Connect the optional KP-10 hand-held keypad. For more information, refer to the
KP-10 External Keypad Installation and Operation Manual.
• Use the optional front panel display/keypad (refer to Section 4.3).
4–1