Comtech EF Data KST-12000 - Manual (Page 29)

Chapter 2. SINGLE-THREAD
SYSTEM INSTALLATION
This chapter provides installation information for single-thread systems.
2.1 Unpacking
The KST-12000 terminal system is packaged in preformed, reusable foam inside a
cardboard carton.
Before unpacking the carton components, ensure that there is plenty of room around the
carton for workspace. A large table is recommended.
To remove the parts:
1. Cut the tape at the top of the carton where it is indicated OPEN THIS END.
2. Lift out the cardboard/foam spacer covering the unit.
3. Remove each part from the carton. Refer to Section 2.2.1 for a parts breakdown.
CAUTION
Because the RFT is heavy, assistance may be necessary to remove
the unit from the box.
Note: Save the packing material for reshipment.
2.2 Inspecting the Equipment
1. Carefully check the equipment for damage incurred during shipment.
2. Carefully check the equipment against the packing list shipped with the
equipment to ensure that the shipment is complete. Refer to the following
paragraphs.
2–1