Comtech EF Data KST-12000 - Manual (Page 43)

KST-12000 Ku-Band Satellite Terminal Revision 4
Single-Thread System Installation MN/KST12000.IOM
c. Install a 5/16” flat washer, 5/16” split lockwasher, and 5/16-18 nut on each
threaded rod.
d. Position the RFT as desired, and tighten the 5/16-18 nuts installed in
Step 6.c.
e. Slide the pipe blocks inward until they contact the vertical pole, then firmly
tighten the 5/16-18 bolts.
2.3.2.2 Square Pole
For square vertical pole installation, follow the steps in Section 2.3.2.1, with the
following exceptions:
• Do not perform Step 4.
• Do not perform Step 6.e.
2–15