Comtech EF Data FX Series Administrator Guide - Manual (Page 37)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 37
Chapter: Overview - FX Series
Section: Mesh Networking with the FX Series
MN-FXSERIESADM6 Rev 5

Mesh configuration with Redundancy
The Redundancy configuration could be set up at each site to provide total redundancy
The fail to wire capability is structured between the two like devices and between the
Remotes and the ADC as shown below.
The appliances are connected in series as shown below.
See the mesh deployment installation pattern for details.
.
Figure 1-4 FX Series Mesh with Redundancy Connectivity Diagram