Comtech EF Data FX Series Administrator Guide - Manual (Page 111)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 111
Chapter: FX Series Status
Section: QOS Status Monitor
MN-FXSERIESADM6 Rev 5
7.2.3 Modem Status:
This block is visible if polling the satellite modem is enabled on the Dynamic ACM screen. In this block,
the modems are identified by IP address, the status as Primary or redundant is identified and the data
rate is identified.
The modem that is active will have a non-zero data rate in the “Data Rate” field. This rate will be that
which is currently being read from the modem. The non active modem rate will be zero.
7.2.4 Output Data Rate:
If polling is not enabled for a satellite modem, then this block will appear. This block will identify the clear
sky data rate configured for the output port.