Comtech EF Data CRS-170A - Manual (Page 17)

CRS-170A L-Band 1:1 Redundancy Switch MN/CRS170A.IOM
Preface Revision 13
xv
• EN 61000-3-2 – Harmonic Currents Emission
• EN 61000-3-3 – Voltage Fluctuations and Flicker.
• Federal Communications Commission Federal Code of Regulation FCC Part 15, Subpart B.
CAUTION – TO ENSURE THAT THE UNIT COMPLIES WITH THESE STANDARDS, OBEY
THESE INSTRUCTIONS:
• Use coaxial cable that is of good quality for connections to the L-Band Type ‘N’ Rx (receive)
female connector.
• Use Type 'D' connectors that have back-shells with continuous metallic shielding.
• Type ‘D’ cabling must have a continuous outer shield (either foil or braid, or both). The
shield must be bonded to the back-shell.
• Operate the Switch and modems with their covers on at all times.
European Union Low Voltage Directive (LVD) (2006/95/EC)
Symbol Description
Type of power cord required for use in the European Community.
! CAUTION: Double-pole/Neutral Fusing
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
International Symbols
Symbol Definition Symbol Definition
Alternating Current Protective Earth
Fuse Chassis Ground
For additional symbols, see the Warnings, Cautions and Notes listed earlier in this
Preface.
European Union RoHS Directive (2002/95/EC)
This unit satisfies (with exemptions) the requirements specified in the European Union Directive
on the Restriction of Hazardous Substances in Electrical and Electronic Equipment (EU RoHS,
Directive 2002/95/EC).