Comtech EF Data MCED-100 - Manual (Page 86)

MCED-100 MetaCarrier Embedding Device Revision 1
Ethernet-based Remote Product Management MN-MCED100
6–20
• Data Bits – Use the drop‐down menu to set the data bits as 8 or 7.
• Serial Parity – Use the drop‐down menu to set parity as Odd, Even, or None.
• Stop bits – Use the drop‐down menu to set the stop bits as 2, 1.5, or 1.
Click [Submit] to save these settings.
6.4.4.5.2 Utility | Reboot
Use this page to perform a soft reboot of the MCED‐100. Note that the function of this page is
identical to the System Reboot section of the ‘Admin | Firmware’ page described earlier.
Figure 6-11. Utility | Reboot page
System Reboot
Click [Reboot] to reboot the unit. A dialogue box
appears to prompt continuation or cancellation of
the reboot process:
Click [OK] to continue the reboot process, or
[Cancel] to abort the process and return to the
‘Utility | Reboot’ page.
Once the reboot process resumes, the ‘Utility | Reboot’ page is replaced with the dynamic
message “Please wait... MCED‐100 is rebooting. Login will be required in XX seconds” – the
time count decrements to 0 seconds before the unit reboots. After the reboot, login is required
once again to resume use of the Web Server Interface.