Comtech EF Data MCED-100 - Manual (Page 64)

MCED-100 MetaCarrier Embedding Device Revision 1
Serial-based Remote Product Management MN-MCED100
5–8
5.3 Remote Commands and Queries
The Serial Interface (the Controller), shown previously in Figure 5‐1, is used to issue remote commands and queries to the MCDD‐100
(the Target). From the Serial Interface command prompt MCDD‐100> type in the command or query packet, using the format explained
previously, for transmission to the MCDD‐100.
For example: MCDD‐100><0000/IPA=010.006.030.001/24 [cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the MCDD‐100. The ‘C’ and
‘Q’ columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only, Query Only, or Command and Query.
INSTRUCTION CODE USED TO... C Q Page
DPW Resets the admin username/password to the factory defaults X 5‐9
IPA Set or query the IP Address and network prefix for the Management | FE port X X 5‐9
IPG Set or query the IP Gateway Address for the Management | FE port X X 5‐9
These Instruction Codes are explained in complete detail in the tables that follow. Note that the Target‐to‐Controller Instruction Code
Qualifiers, described earlier, that appear in the “Response to Command” column carry the following meanings:
= Message OK.
? Received OK, but invalid arguments were found.
* Message OK, but not permitted in current mode.
# Message OK, but unit is not in Remote mode.
! Invalid instruction.