Comtech EF Data MCED-100 - Manual (Page 35)

MCED-100 MetaCarrier Embedding Device Revision 1
Installation MN-MCED100
2–5
Tools needed to install the KT‐0000168 (4”) or KT‐0000195 (10”) Bracket Kit (Figure 2‐3):
• A medium Phillips™ screwdriver
• A 5/32‐inch SAE Allen™ Wrench
• An adjustable Crescent™ wrench.
Follow these steps to install the Radyne‐style chassis kit:
Step Description
1
Assemble the Adapter Plates to the back side of the MCED‐100 chassis using the #10
Flat Head Screws.
2
Assemble the #10 Shoulder Screws through the Adapter Plate mounting slots using
the #10 Flat Washers, #10 Split Washers, and #10 Hex Nuts.
3
Mount the Rear Support Brackets to the rack enclosure threaded rear mounting
rails using the #10 Rack Bracket Bolts.
4
Slide the MCED‐100 into the front of the rack enclosure. Make sure that the #10
Shoulder Screws properly engage into the slots of the Rear Support Brackets.