Comtech EF Data MCED-100 - Manual (Page 49)

MCED-100 MetaCarrier Embedding Device Revision 1
Updating Firmware MN-MCED100
4–3
D. On the PC: Review and record the information displayed on the MCED‐100 Serial
Interface:
• Management IP Address (factory default is 192.168.1.4/24)
• Firmware Number (FW‐0000418) and Release Version (e.g., 1.1.1)
See Chapter 5. SERIAL‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the MCED‐100 Serial Command Line
Interface.
E. Alternately, use the MCED‐100 Web Server Interface to obtain the firmare information.
• CONNECT THE MCED‐100 ‘ETHERNET MANAGEMENT’ PORT TO AN ETHERNET PORT
ON THE USER PC USING A HUB, A SWITCH, OR A DIRECT ETHERNET CABLE
CONNECTION:
• ON THE USER PC: USE A WEB BROWSER (e.g., INTERNET EXPLORER) TO OPEN THE
MCED‐100 WEB SERVER INTERFACE’S ‘ADMIN | FIRMWARE’ PAGE, AND THEN VIEW
THE SLOT1 AND SLOT2 FIRMWARE LOADS:
See Chapter 6. ETHERNET‐BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the MCED‐100 Web Server
Interface.