Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 9)

Snap Linear Knife Installing Linear Knife – See Appendix A 
9
Installing Linear Knife
– See Appendix A
See Appendix A for Linear Knife Installation Instructions.
Threading
To thread the stock through the SNAP 700 Linear Knife, bring the stock up
to the entry point of the knife. Once the stock comes in contact between the
upper and lower rollers, turn the feed knob clockwise. The stock will
traverse through the knife and exit out the nip assembly.
You will need to rotate both the printer feed knob and the linear knife feed
knob. The feed on the linear knife will not pull the material through the
printer. The feed in the linear knife is for take-up tension only.